*Due to increased volume, PCM and IDM rebuilds are on a 4-5 day backlog. Expedited shipping does not speed up the rebuild time, just the shipping once it leaves our facility.*
Diesel Technology Of Chattanooga will be closed on July 4th 2022 for Independence Day!
*Due to increased volume, PCM and IDM rebuilds are on a 4-5 day backlog. Expedited shipping does not speed up the rebuild time, just the shipping once it leaves our facility.*
Diesel Technology Of Chattanooga will be closed on July 4th 2022 for Independence Day!
Illustration 1: Whoo Hoo!!! Stuff is happening! The front block wall has been cut out for the office main entrance, and you can see clear through to the back wall where they have also started cutting it out for the bay door.

Illustration 2: This is looking from the shop back door into the office and main entrance. Notice the floor? It's been ground down to back concrete, too. On this side of the bathroom stud wall will be a big “laundry” sink with an overhead sprayer for the initial cleaning of the outsides of the modules we get in for rebuilding. After 20+ years, many of them are pretty grungy!

Illustration 3: This is the shop alcove. The door to the left goes into the Paint 'n Prep room.

Illustration 4: And looking the opposite way from the previous photo, from the alcove across the shop towards the office and bathroom. We'll be installing electronics repair work stations along the wall on the left and the office wall.

Illustration 6: Close-up of the concrete after grinding off all the adhesive and crud.
Illustration 1: Whoo Hoo!!! Stuff is happening! The front block wall has been cut out for the office main entrance, and you can see clear through to the back wall where they have also started cutting it out for the bay door.

Illustration 2: This is looking from the shop back door into the office and main entrance. Notice the floor? It's been ground down to back concrete, too. On this side of the bathroom stud wall will be a big “laundry” sink with an overhead sprayer for the initial cleaning of the outsides of the modules we get in for rebuilding. After 20+ years, many of them are pretty grungy!

Illustration 3: This is the shop alcove. The door to the left goes into the Paint 'n Prep room.

Illustration 4: And looking the opposite way from the previous photo, from the alcove across the shop towards the office and bathroom. We'll be installing electronics repair work stations along the wall on the left and the office wall.

Illustration 6: Close-up of the concrete after grinding off all the adhesive and crud.
By Billy Crush

Share:

Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page